PHPBuilder - On User-Defined Timezones in PHP Page 3



RSS Twitter
Articles Php Functions

On User-Defined Timezones in PHP - Page 3

by: David Whittington
|
September 11, 2003

The Big Mess

The problem as we saw it was this: there are two distinct possibilities of what 'mktime' returns (probably more, but we doubt that any of them are sensible). Either 'mktime' returns a timestamp which represents seconds since the epoch in the local timezone or it returns a timestamp which represents seconds since the epoch in GMT.
If 'mktime' returns a timestamp in local time then the conversion to a timestamp in GMT would be a simple one. Because under these assumptions 'mktime' is not applying an offset (both the input and output are relative to the server) all we need to do to convert the output is to apply the user's offset. If on the other hand 'mktime' returns a timestamp which represents seconds since the epoch in GMT then the conversion of the timestamp is not so simple. Remember that any conversion applied by 'mktime' is always performed relative to the server's timezone, so even though 'mktime' under these assumption would try to return a time in GMT it would fail because it would apply the server's offset rather than the user's offset. To solve this problem we would have to figure out the difference between the server's offset and the user's offset, in other words, the user's offset from the server, and then subtract that value from the timestamp returned by 'mktime'.
Hypothesis 1 and 2
Hopefully, this hasn't confused anyone to the point of madness like it did us. If it has, hang on. The solution is quite simple. As all you true hardcore *nix wizards out there already know, timestamps are always stored as seconds since the epoch in GMT. In fact the epoch is defined as being in GMT. A a technicality for sure, but an important one. If you keep in mind that all PHP functions deal with timestamps in GMT then your timestamp problems will be greatly reduced. Also, if it helps you can demonstrate that this is the case; just run the following code:

<?php

echo mktime(0,0,0,1,1,1970);

?>
It should return something other than 0 (unless you somehow live in GMT) thus indicating that PHP is applying the servers offset to translate the time values passed into 'mktime' to a timestamp that is relative to GMT.
What this means in terms of our previous discussion is that our second hypothesis was the correct one. 'mktime' returns a timestamp representing seconds since the epoch, the epoch being in GMT of course. Just in case there is any lingering confusion, below is a description of what PHP's date functions do.
Actual PHP Behavior chart
In slightly more verbose terms:
gmtime, mktime, gmdate and date charts

« Previous Page
1
|
2
|
3
|
4
|
5
Next Page »

Comment and Contribute

Your comment has been submitted and is pending approval.

Author:
David Whittington

Comment:



Comment:

(Maximum characters: 1200). You have characters left.